Servicing The Lcb Based On Led Status; Tape Drive Leds - Quantum scalar i500 User Manual

Servicing the LCB Based
on LED Status

Tape Drive LEDs

Figure 71 Location of Tape
Drive LEDs
Scalar i500 User's Guide
1 Observe the blinking patterns of the LEDs for at least 30 seconds.
13
2 Capture a snapshot of the library, and send it to Quantum Technical
Support for analysis.
RAS tickets typically report all problems related to tape drives, including
13
error codes and TapeAlerts. By observing the blinking pattern of LEDs on
tape drives, however, you can discern which operation the tape drive is
currently performing.
Figure 71 shows where the tape drive LEDs and the fibre port link LED
are located.
1 Fibre Port LED
2 Tape Drive LEDs
Use Table 16 to interpret tape drive activity:
Chapter 13 Troubleshooting
Interpreting LEDs
511