Scalar I500 User's Guide - Quantum scalar i500 User Manual

Item
Session ID
State
Start Time
Finish Time
Results

Scalar i500 User's Guide

The table displays the set of media tests that have run based on the
time range selected. Each row in the table presents an overview of a
single EDLM test session. The table displays the following
information about the test sessions:
Description
The session identifier, a unique number assigned to each test session that was
run.
Pending, Complete, In Progress, Stopped, or Paused.
The date and time the test session was started.
The date and time the test session completed.
A summary of results for all media tested in the session. The reported values
include the number of tapes scanned (in parentheses) for each result obtained.
Note: To view results for individual tapes in the session, select a test session
row and then click the Details button.
Results are the following:
• Good — The tape is good.
• Bad — The tape is bad.
• Suspect — The tape is possibly unreliable or defective.
• Untested— The tape could not be fully scanned, for various reasons,
including: incompatible media; cartridge could not be loaded; tape is
encrypted but the data encryption key could not be obtained; drive not
communicating with I/O blade, test was stopped.
Note: Untested media do not initiate RAS tickets or EDLM media action
policies (such as copying data from a bad or suspect tape).
• Not Completed — The test has not completed yet.
3 From the Select Time Range drop-down list, select the range of time
for test sessions that you want displayed. The time range is based on
the start time of the test session. Choose one of the following:
• Last Day — Test sessions that were run in the last 24 hours.
• Last Week — Test sessions that were run in the last seven days.
• Last Month — Test sessions that were run in the last month.
Chapter 8 Extended Data Lifecycle Management
Incomplete EDLM Scans
232