Scalar I500 User's Guide - Quantum scalar i500 User Manual

Scalar i500 User's Guide

Open the module's access door and raise the guide pin by pulling
c
it up and turning it slightly as if it were a screw. Otherwise, the
guide pin may scratch the front doors of the module on which
you are stacking it.
5 Lift the module, align it so that it is parallel with the module below it,
and slide it into place.
6 Lower the module's guide pin by turning it and pushing it down.
7 Secure the module to the module beneath it by tightening the
thumbscrews located at the base of the front and back of the module.
Press down the thumbscrew, and then tighten it.
Chapter 12 Installing, Removing, and Replacing
Installing the Library in a Rack
1 Guide pin
2 Thumbscrew
439