Quantum scalar i500 User Manual page 428

Scalar i500 User's Guide
Removing and Replacing the Library Control Blade and LCB Compact Flash Card
Instructions
The Compact Flash Card is new and has never been initialized. It contains
only a minimal level of library firmware which allows the library to boot
up and display an Upgrade Notification message. Once you install the
LCB/compact flash card, you will need to upgrade firmware and
reconfigure your network settings.
Do not separate the old compact flash card from the library
Note:
control blade (unless you are replacing the compact flash card
only). Return the old LCB/compact flash card as a pair to
Quantum.
1 If possible, save the library configuration (see
Configuration on page 495).
2 Power off the library.
3 Disconnect all cables from the existing LCB. You may want to label
each cable that is connected to the existing LCB to make sure that you
can correctly reconnect them to the new LCB.
4 Remove the existing LCB from the library.
To remove the existing LCB, release both of the LCB latch hooks and,
using the latch hooks as handles, pull the entire LCB toward you.
Chapter 12 Installing, Removing, and Replacing
12
Saving the Library
409