Unstacking The Existing Modules - Quantum scalar i500 User Manual

Unstacking the Existing
Modules
Scalar i500 User's Guide
Unstack the modules as follows:
12
1 Starting with the topmost module of your library, open the I/E
station and access doors.
Caution:
2 If your current configuration already uses an expansion module,
disengage the Y-rails so the modules can be safely unstacked.
a From the front of the library, find the Y-rail release mechanism,
which is located on the left side of the module. Squeeze the
handle of the Y-rail release mechanism, lift it, and release it so
that it locks into place.
From the rear of the library, find the rear Y-rail release
b
mechanism located in the interior of the right side of the module.
Squeeze the handle of the Y-rail release mechanism, lift it, and
release it so that it locks into place.
Note: The rear Y-rail is impossible to lift up with the tape drives
installed.
Chapter 12 Installing, Removing, and Replacing
Adding Expansion Modules to an Existing Library
Before unstacking the modules, the robot
assembly must be parked as described in
Preparing to Install an Additional Expansion
Module above.
348