Chapter 12 Installing, Removing, And Replacing; Scalar I500 User's Guide - Quantum scalar i500 User Manual

Hide thumbs Also See for scalar i500:

Table of Contents

Installing, Removing, and

This chapter describes how to add, remove, and replace hardware within

your library. Adding, removing, or replacing library components may

require you to power off the entire library. There are a few components,

however, that you can service without powering off the library, such as

replacing tape drives. Instead, you may only need to take a specific

partition offline, or you may not need to impact the status of the library at

All libraries taller than 14U must be installed in a rack

having a main protective earthing (grounding) terminal,

and power must be supplied via an industrial plug and

socket-outlet and/or an appliance coupler complying with

IEC 60309 (or an equivalent national standard) and having

a protective earth (ground) conductor with a cross

sectional area of at least 1.5 mm

To ensure proper airflow and access space, allow 60 cm (24

inches) in the front and back of the library.

Under no circumstances should a rack be moved while

loaded with one or more modules.

Show Quick Links

Chapters

Table of Contents