Figure 66 Installing The Ethernet Expansion Blade - Quantum scalar i500 User Manual

Figure 66 Installing the
Ethernet Expansion Blade
Double-
wide cover
plate
Expansion blade
Latch
hooks,
closed
LEDs
Scalar i500 User's Guide
Tape Drive Ethernet Connectivity and the Ethernet Expansion Blade
Cover
Ethernet
plate
13 Cable the Ethernet Expansion blade (see
Expansion Blade
14 Power on the library.
15 Verify the Ethernet Expansion blade is in the "Ready" state using one
of these methods:
• Check the LEDs on the Ethernet Expansion blade. The green LED
should blink once per second, the blue LED should blink once
every 10 seconds, and the amber LED should be off.
Chapter 12 Installing, Removing, and Replacing
on page 474).
Cabling the Ethernet
473