Scalar I500 User's Guide - Quantum scalar i500 User Manual

Scalar i500 User's Guide

2 Lift the new expansion module and, from the front of the library,
place it in the desired location.
3 If stacking the expansion module on top of another module, secure
the two modules together by tightening the two thumbscrews at the
base of the front of the module and the two thumbscrews located at
the base of the back of the module. Then lower the module's guide
pin (located at the base of the front of the module) by turning it and
pushing it down.
4 Tighten all thumbscrews located at the base of the front and back of
the modules.
5 Fasten the module to the rack with rack ears. See
Library in a Rack on page 423 for information on installing a
rackmount kit.
6 If stacking the expansion module on top of another module, engage
the Y-rails of the new module in your library configuration. Ensure
that the Y-rails are properly aligned and the thumbscrews are
tightened.
Chapter 12 Installing, Removing, and Replacing
Installing a New Multi-Module Library Configuration
1 Guide pin
2 Thumbscrew
Installing the
337