Viewing the System Information Report
Scalar i500 User's Guide
The System Information Report contains information on the following
library settings:
•
— current date, time, and time zone settings
Date and time
•
— host name, Internet Protocol (IP) address(es), serial
Physical library
number, firmware version, board support package (BSP) level, the
date the BSP was last updated, and robot firmware version.
•
(this section displays only if encryption key management
Encryption
is licensed and configured on the library) — key server type;
encryption software version; SSL connection (enabled/disabled);
primary host (primary key server IP address or host name), primary
key server port number; primary key server serial number; secondary
host (secondary key server IP address or host name); secondary key
server port number; secondary key server serial number.
•
Library Partitions
encryption method, encryption system type, number of slots, number
of media, number of tape drives, and whether FIPS is configured for
each partition.
•
location coordinates, vendor name, model, type,
Tape drives —
physical serial number (P-SN), logical serial number (L-SN),
firmware level, sled boot version, sled application version,
encryption method, and whether the tape drive is connected to an
I/O blade.
•
— if the library contains FC I/O blades, this table lists
FC I/O blades
the location coordinates, World Wide Node Name (WWNN),
firmware level, and ready status.
•
— if the library contains Ethernet Expansion blades, this
EE blades
table lists the location coordinates and status.
The path to open the report from the Web client is
.
Information
Chapter 10 Getting Information – Logs and Reports
Viewing the System Information Report
— name, serial number, control path, mode,
Reports > System
271