Scalar I500 User's Guide - Quantum scalar i500 User Manual

Scalar i500 User's Guide

1 Library control blade (LCB)
2 GB Ethernet port
3 Power supplies
4 Power cords
5 Ethernet cables from LCB to
expansion module (one per FC
I/O blade)
6 FC cable from FC I/O blade to
tape drive
None
Required tools:
1 If your library is larger than 14U, install it in a rack. See
Library in a Rack
include procedures for removing and replacing tape drives.
All libraries taller than 14U must be installed in a rack
Warning:
having a main protective earthing (grounding) terminal,
and power must be supplied via an industrial plug and
socket-outlet and/or an appliance coupler complying with
IEC 60309 (or an equivalent national standard) and having
a protective earth (ground) conductor with a cross
sectional area of at least 1.5 mm
To ensure proper airflow and access space, Allow 60 cm
(24 inches) in the front and back of the library.
Note: Pay attention to where the operator panel is positioned in the
rack for optimum usability.
Chapter 12 Installing, Removing, and Replacing
7
8
9
10 Ethernet cable to network
11 UPPER and LOWER
on page 423 for instructions. The instructions
Cabling the Library
Module terminator
FC cable to host
Module-to-module cable
Ethernet ports
Installing the
2
(14 AWG).
315