Ethernet Expansion Blade Control - Quantum scalar i500 User Manual

Ethernet Expansion
Blade Control
Scalar i500 User's Guide
The Ethernet Expansion Blade Control menu allows you to perform the
13
following functions:
• Power Cycling the Ethernet Expansion Blade
• Removing an Ethernet Expansion Blade from the Library's
Configuration
Power Cycling the Ethernet Expansion Blade
Administrators can power cycle individual Ethernet Expansion blades in
the library. You might want to power cycle an individual Ethernet
Expansion blade when troubleshooting, such as when resolving a
Reliability, Availability, and Serviceability (RAS) ticket.
From the
EE Blade Control
the Ethernet Expansion blade you want to power cycle.
Note: Power cycling an Ethernet Expansion blade may cause key
exchange failures if FIPS is enabled.
It takes approximately 1 minute to power cycle an Ethernet Expansion
blade. The status displays as "Booting" during the power cycle.
You can only power cycle the Ethernet Expansion blade from the Web
client. The path to open the appropriate screen is as follows:
• From the Web client, select
.
Control
Removing an Ethernet Expansion Blade from the Library's
Configuration
This feature is described in detail in
an Ethernet Expansion Blade
Chapter 13 Troubleshooting
screen, click the
Cycle
Tools > Diagnostics > Drives > EE Blade
Permanently Removing or Relocating
on page 478.
Drive Diagnostics
button corresponding to
13
13
522