Scalar I500 User's Guide - Quantum scalar i500 User Manual

Scalar i500 User's Guide

Warning: All libraries taller than 14U must be installed in a rack
having a main protective earthing (grounding) terminal,
and power must be supplied via an industrial plug and
socket-outlet and/or an appliance coupler complying with
IEC 60309 (or an equivalent national standard) and having
a protective earth (ground) conductor with a cross
sectional area of at least 1.5 mm
To ensure proper airflow and access space, Allow 60 cm
(24 inches) in the front and back of the library.
Pay attention to where the operator panel is positioned in the
Note:
rack for optimum usability.
1 If your library is larger than 14U, install it in a rack.
See Installing the Library in a Rack
instructions include procedures for removing and replacing tape
drives.
2 Connect the fibre cables to the tape drives.
a Attach one end of the fibre cable to the fibre port on each tape
drive.
b Attach the other end of the cable to the host or switch.
Note: The fibre cable can be connected from the tape drive to a
switch rather than a host.
3 Connect the module terminators.
Caution: The module terminator is not the same as a SCSI
terminator. Using a SCSI terminator instead of a
module terminator will damage the library.
Chapter 12 Installing, Removing, and Replacing
2
(14 AWG).
on page 423 for instructions. The
Cabling the Library
310