CONFIGURING, INSTALLING, AND OPERATING THE
This chapter contains information needed for the integration of the tape system into a
system or subsystem. This includes safety and handling instructions, configuration
jumper settings, connector pin assignments, installation instructions, power and
signal cabling descriptions, and operating instructions.
2.1
Safety, Handling, and Electrostatic Discharge (ESD) Protection
Inappropriate or careless handling of tape systems may result in damage to the
product. Follow the precautions and directions to prevent damaging the tape system.
2.1.1 Safety Precautions
For your safety, follow all safety procedures described here and in other sections of the
manual.
•
Remove power from the computer system (or expansion unit) before installing or
removing the tape system to prevent the possibility of electrical shock or damage
to the tape system. Unplug the unit that contains or is to contain the system from
ac power to provide an added measure of safety.
•
Read, understand, and observe any and all label warnings.
2.1.2 Handling
Damage to the system can occur as the result of careless handling, vibration, shock, or
electrostatic discharge (ESD). Always handle the tape system with care to avoid
damage to the precision internal components.
Follow these guidelines to avoid damage to the system:
•
Always observe prescribed ESD precautions.
•
Keep the system in its anti-static bag until ready to install.
•
Always use a properly fitted wrist strap or other suitable ESD protection when
handling the system.
•
Hold system only by its sides. Do not touch any components on the PCBA.
Quantum DLT 8000 Tape System
Chapter 2
TAPE SYSTEM
2-1