Scalar I500 User's Guide - Quantum scalar i500 User Manual

Scalar i500 User's Guide

•
If you are using IPv6:
select the
Enable IPv6
IPv6 but you will not be prompted to configure IPv6 settings
here. Continue with the Setup Wizard screens. Then, when you
are finished using the Setup Wizard, configure the IPv6 network
settings by going to
4 Log out of the operator panel.
5 Using the default administrator account, log in to the Web client.
Type in the
admin
text box.
6 Complete the
Setup Wizard
final
Setup Wizard
When you have completed the
Configuration report appears on the Web client. The Library
Configuration report provides information on the library's tape
drives, partitions, I/E stations, storage slots, cleaning slots, and
loaded media. See
page 272 for more information on the Library Configuration report.
Depending on the size of the library, there may be a slight
Note:
delay after you apply the settings in the Setup Wizard
while the Library Configuration report page loads.
Details on using the
Setup Wizard
• The only time that you do not need to log in to the library is when the
Setup Wizard appears on the operator panel the first time the library
is powered on.
• After a timeout period of one hour, the Setup Wizard will close, and
you will be logged out of the library. Use the default administrator
account to log in to the operator panel.
• If you time out of the Setup Wizard or do not complete all the Setup
Wizard screens, the library will apply the default configuration
settings plus whatever modifications you made (see
Configuration Settings
• You cannot log in to the library from the Web client until you have
configured network settings on the operator panel. To change IPv4
settings and configure IPv6 settings, go to
Chapter 3 Configuring Your Library
On the
Setup Wizard: Enable IPv6
check box and click
Setup > Network Mgmt
text box and
User Name
screens on the Web client interface. The
screen will prompt you to apply your settings.
Setup Wizard
Viewing the Library Configuration Report
include:
on page 57).
Using the Setup Wizard
screen,
. You have enabled
Next
on the operator panel.
in the
password Password
, the Library
on
Default
Setup > Network Mgmt
.
56