Scalar I500 User's Guide - Quantum scalar i500 User Manual

Scalar i500 User's Guide

Details on network settings include:
• is the network name you want to assign to the library.
Library Name
The library name is limited to 12 lowercase alphanumeric characters
and dashes (-).
• defaults to enabled. When DHCP is enabled, the library obtains
DHCP
an IP address automatically. If DHCP is not enabled, you must
manually enter an IP address, default gateway, and subnet mask/net
prefix.
• must be entered in dot notation (for example,
IPv4 addresses
192.168.0.1). They are limited to numeric characters and do not allow
values exceeding 255 for dot-separated values.
• must be entered in the proper notation. IPv6 address
IPv6 addresses
can be entered in the most common notation, as eight groups of four
hexadecimal digits. 2001:0ff8:55cc:033b:1319:8a2e:01de:1374 is an
example of a valid IPv6 address. Also, if one or more of the four-digit
groups contains 0000, you can omit the zeros and replace them with
two colons (::), as long as there is only one double colon used in an
address. Using this notation, 2001:0ff8:0000:0000:0000:0000:01de:1374
is the same as 2001:0ff8::01de:1374.
• is the IP address of the library. For IPv4, this text box is
IP Address
available only if DHCP is disabled.
•
Default Gateway Address
your portion of the Ethernet network. For IPv4, this text box is
available only if DHCP is disabled.
• (IPv4 only). Text box is available only if DHCP is
Subnet Mask
disabled.
• (IPv6 only).
Network Prefix
•
Primary DNS Address
an IP address. This text box is available only if DHCP is disabled.
•
Secondary DNS Address
as an IP address. This text box is available only if DHCP is disabled.
• (operator panel only) allows you to change the
Port Settings
autonegotiate mode, speed, and duplex settings on the Ethernet port.
Chapter 3 Configuring Your Library
is the IP address of the default gateway for
(optional, Web client only) must be entered as
(optional, Web client only) must be entered
Managing the Network
61