Viewing The Network Settings Report - Quantum scalar i500 User Manual

Viewing the Network Settings Report

Scalar i500 User's Guide
The Network Setings Report provides information on the following
library network settings:
• — host name, primary DNS, alternate DNS.
Network
• — Dynamic Host Configuration Protocol (DHCP)
IPv4 Settings
enabled/disabled, IP address, gateway address, and net mask.
• (if IPv6 is enabled) — DHCP enabled/disabled,
IPv6 Settings
Stateless enabled/disabled, Static enabled/disabled, network prefix,
gateway, and all IPv6 addresses.
• — SSL, port, and cipher of the library.
SSL
• — access and state enabled/disabled settings of the library.
SMI-S
• : Indicates whether the SMI-S port for SMI-S traffic to the
Access
library (port 5988) is enabled or disabled. You can change the
setting via the operator panel,
setting is enabled.
• : Indicates whether allowing SMI-S to run on the library is
State
enabled or disabled. You can change this setting on the operator
panel,
Tools > System Settings
• — access enabled/disabled, V1 enabled/disabled, V2
SNMP
enabled/disabled, V3 enabled/disabled, algorithm, encryption
enabled/disabled, and port.
• — IP addresses and ports.
SNMP-Traps
The path to open the report from the Web client is
.
Settings
Chapter 10 Getting Information – Logs and Reports
Viewing the Network Settings Report
Tools > Security
. The default is disabled.
menu. The default
Reports > Network
275