Scalar I500 User's Guide - Quantum scalar i500 User Manual

Scalar i500 User's Guide

test again, the new information overwrites the previous information.
This option presents the summary log. For more information, see
Using the Installation Verification Test
•
Installation Verification Test Detailed Log
you run the Installation Verification Test (IVT). The log saves only the
information from the most recently run test. If you run the test again,
the new information overwrites the previous information. This
option presents the detailed log. For more information, see
Installation Verification Test
•
Command History Log
blades. When you select this report, you choose the FC I/O blade and
device for which you want to run the report. The
FC I/O blades installed in the library (if more than one are installed).
The menu lists the devices associated with the selected FC
Devices
I/O blade. The report shows all commands from the selected device
to the selected blade. When the log file reaches its maximum size, the
oldest information is replaced as new information is added.
• — Shows all cleanings that have been performed in the
Cleaning Log
library since firmware version 520G was installed. When the log
reaches its maximum size, the oldest information is replaced as new
information is added. The comma-separated values (csv) file
provides the following information:
Date Time (date and time); Barcode (barcode of the cleaning
cartridge); Tape (location coordinates of the cleaning cartridge);
Drive (location coordinates of the tape drive that was cleaned); Status
(pass/fail); Return Code (service use only), Cleaning Type (Manual,
Auto, MoveMedium), Expired ("Invalid" if the tape is expired or a
data tape was improperly used to clean; "-" if not applicable); Usage
Count ("N/A" if the cleaning did not complete); Reserved.
• — Shows current information for all slots in the
Slot Position Log
library. The comma-separated values (csv) file provides the following
information for each slot:
Date and Time, Slot Type (Picker, Drive, Storage, or IE), Object
Present? (Y, N), Location Coordinates, X Position, Y Position, Angle
Position, X Calibration Offset, Y Calibration Offset.
• — Records all RAS tickets for the library. When the
RAS Tickets Log
log file reaches its maximum size, the oldest information is replaced
as new information is added.
Chapter 10 Getting Information – Logs and Reports
Viewing, Saving, and E-mailing Library Logs
on page 515.
— This log is saved each time
on page 515.
— Available only if you are using FC I/O
Using the
menu lists all
Blade
278