Errors - Lexmark CX825 Service Manual

Action
Step 29
a
Reseat all connectors on the MSHPF controller board.
b
Make sure that the cables are properly routed, and then reset
the printer.
Does the problem remain?
Step 30
Replace the MSHPF controller board. See
board removal" on page
Does the problem remain?
374–383 errors
374–383 error messages
Error code Description
374.60 The motor (standard bin elevator) did not turn on.
374.61 The motor (standard bin elevator) did not turn off.
377.60 The motor (stapler bin elevator) did not turn on.
377.61 The motor (stapler bin elevator) did not turn off.
383.60 The motor (staple unit carriage) did not turn on.
383.61 The motor (staple unit carriage) did not turn off.
MSHPF standard bin stack failure service check
Action
Step 1
a
Check the MSHPF for proper installation, and then check its
paper path. See "Procedure before starting the MSHPF
service checks" on page
b
Enter the Diagnostics menu, select Output bin quick feed >
select bin, and then touch Single or Continuous.
Does the problem remain?
Step 2
a
Enter the Diagnostics menu, and then navigate to:
Output device diagnostics > Motor tests > Finisher > Standard
bin elevator
b
Touch Start.
Does the motor run?
"MSHPF controller
937.
256.
Diagnostic information
Yes
Go to step 30.
Contact the next
level of support.
Action
See "MSHPF standard bin stack failure service
check" on page
See "Stapler bin stack failure service check" on
page 517.
See "Staple carriage jam service check" on
page 376.
Yes
Go to step 2.
Go to step 5.
512
No
The problem is
solved.
The problem is
solved.
512.
No
The problem is
solved.
Go to step 3.
7564