Lexmark CX825 Service Manual page 565

Action
Step 3
Check the staple finisher rear cover for proper installation and
damage, and replace if necessary. See
removal" on page 788.
Does the problem remain?
Step 4
a
Enter the Diagnostics menu, and then navigate to:
Output device diagnostics > Sensor tests > Staple Finisher >
Door test
b
Find the switch (Staple door).
Does the switch status change while toggling the switch?
Step 5
a
Check the staple finisher staple cartridge door switch for
proper installation and damage, and replace if necessary. See
"Staple finisher staple cartridge door switch removal" on
page 794.
b
Reseat the switch cable.
Step 6
Check the cables for cuts or damages, and replace if necessary.
Does the problem remain?
Step 7
Reseat all connectors in the staple finisher controller board, and
then reset the printer.
Does the problem remain?
Staple finisher bin full service check
Action
Step 1
a
Clear the staple finisher bin.
b
Clear the paper path of any obstruction.
c
Reset the printer, and then reseat the staple finisher.
Does the problem remain?
Step 2
Clear the output bin.
Does the problem remain?
"Staple finisher rear cover
Diagnostic information
565
Yes No
Go to step 4. The problem is
solved.
Go to step 6. Go to step 5.
Go to step 6. The problem is
solved.
Go to step 7. The problem is
solved.
Contact the next The problem is
level of support. solved.
Yes No
Go to step 2. The problem is
solved.
Go to step 3. The problem is
solved.
7564