Y Errors - Lexmark CX825 Service Manual

Action
Step 9
Replace the motor (redrive).
Does the problem remain?
Step 10
Reset the printer.
Does the problem remain?
Step 11
Replace the controller board. See
page 677.
Does the problem remain?

15y errors

150–158 error messages
Error code Description
150.80 The motor (duplex) did not turn on.
150.81 The motor (duplex) did not turn off.
150.82 The motor (duplex) speed did not ramp up to the
required level.
150.83 The motor (duplex) stalled.
150.84 The motor (duplex) ran too slow.
150.85 The motor (duplex) ran too fast.
151.80 The motor (transfer belt) did not turn on.
151.81 The motor (transfer belt) did not turn off.
151.82 The motor (transfer belt) speed did not ramp up to
the required level.
151.83 The motor (transfer belt) stalled.
151.84 The motor (transfer belt) ran too slow.
151.85 The motor (transfer belt) ran too fast.
"Controller board removal" on
Diagnostic information
432
Yes
Go to step 10.
Go to step 11.
Contact the next
level of support.
Action
See "Motor (duplex) failure service check" on
page 434.
See "Motor (transfer belt) failure service
check" on page 435.
7564
No
The problem is
solved.
The problem is
solved.
The problem is
solved.