Lexmark CX825 Service Manual page 310

Action
Step 15
Reinstall or replace the diverter. See
on page 1099.
Does the problem remain?
Step 16
a
Enter the Diagnostics menu, and then navigate to:
Output device diagnostics > Motor tests > Finisher > Mid-
transport
b
Touch Start.
Does the motor run?
Step 17
Reseat the motor cable, and then check the motor for misalignment
and damage.
Is the motor properly installed and free of damage?
Step 18
Reinstall or replace the motor. See
removal" on page 1001.
Does the problem remain?
Step 19
Check the MSHPF standard bin exit belt for misalignment and
damage.
Note: Make sure that there are no other parts interfering with the
movement of the belt.
Is the belt properly installed and free of damage?
Step 20
Reinstall or replace the belt. See
removal" on page 996.
Does the problem remain?
Step 21
Check the mid-transport diverter cams and gear for misalignment
and damage.
Are the cams and gear properly installed and free of damage?
Step 22
Reinstall or replace the cams and gear. See
diverter cams and gear removal" on page
Does the problem remain?
"Staging diverter removal"
"Motor (mid-transport)
"MSHPF standard bin exit belt
"Mid-transport
1035.
Diagnostic information
310
Yes No
Go to step 16. The problem is
solved.
Go to step 19. Go to step 17.
Go to step 19. Go to step 18.
Go to step 19. The problem is
solved.
Go to step 21. Go to step 20.
Go to step 21. The problem is
solved.
Go to step 23. Go to step 22.
Go to step 23. The problem is
solved.
7564