Lexmark CX825 Service Manual page 528

Action
Step 5
Check the K printhead wiper for proper movement.
a
Remove the transfer belt. See
page 652.
b
Close door B and door A.
c
Enter the Diagnostics menu, and then navigate to:
Printer diagnostics & adjustments > Motor tests > Printhead
wiper
d
Open door A, and then touch Start.
Does the printhead wiper properly move?
Step 6
Check the motor (printhead wiper) cable and socket JPWR1 on the
controller board for proper connection.
Is the motor cable properly connected?
Step 7
Check the sensor (auto alignment) cables and socket JTPS2 on the
controller board for proper connection.
Are the sensor cables properly connected?
"Transfer belt removal" on
Diagnostic information
528
Yes No
Go to step 7. Go to step 6.
Replace the motor. Reseat the cable,
See "Motor and then perform
(printhead wiper) again the Auto
removal" on alignment service
page 639. Perform check.
again the Auto
alignment service
check.
Go to step 8. Reseat the cable,
and then perform
again the Auto
alignment service
check.
7564