Lexmark CX825 Service Manual page 130

Action
Step 14
Reinstall or replace the separator pad. See
removal" on page 655.
Does the problem remain?
Step 15
Check the condition of the tray 5 pick roller.
Is the pick roller free from excess wear, contamination, and
damage?
Step 16
Replace the pick roller. See
Does the problem remain?
Step 17
a
Check the pick roller for proper installation.
b
Fully press the pick roller assembly upward to make sure the
mounting latches are properly engaging the slot on the shaft.
Is the pick roller assembly properly installed?
Step 18
Reinstall the pick roller assembly.
Does the problem remain?
Step 19
Check the paper path along the tray 5 exit.
Is the paper path free of fragments and contamination?
Step 20
Clean the paper path.
Does the problem remain?
Step 21
a
Enter the Diagnostics menu, and then navigate to:
Printer diagnostics & adjustments > Sensor tests
b
Find the sensor (Input).
Does the sensor status change while toggling the sensor?
Step 22
Check the sensor cable for proper connection, and then reseat if
necessary.
Does the problem remain?
"Separator pad
"Pick roller removal" on page
Diagnostic information
130
Yes
Go to step 15.
Go to step 17.
Go to step 17.
654.
Go to step 19.
Go to step 19.
Go to step 21.
Go to step 21.
Go to step 24.
Go to step 23.
7564
No
The problem is
solved.
Go to step 16.
The problem is
solved.
Go to step 18.
The problem is
solved.
Go to step 20.
The problem is
solved.
Go to step 22.
The problem is
solved.