Sensor (Staple Finisher Tamper Position) Removal - Lexmark CX825 Service Manual

Sensor (staple finisher tamper position) removal
1
Remove the right cover. See
2
Remove the rear cover. See
3
Remove the inner rear cover. See
4
Remove the front cover. See
5
Remove the tamper assembly. See
6
Remove the tamper top cover. See
7
Remove the sensor holders, and then remove the sensors.
Motor (staple finisher tamper) removal
1
Remove the right cover. See
2
Remove the rear cover. See
3
Remove the controller board. See
4
Remove the inner rear cover. See
"Staple finisher right cover removal" on page
"Staple finisher rear cover removal" on page
"Staple finisher inner rear cover removal" on page
"Staple finisher front cover removal" on page
"Staple finisher tamper assembly removal" on page
"Staple finisher tamper top cover removal" on page
1
1 Sensor (staple finisher front tamper home)
2 Sensor (staple finisher narrow media tamper)
3 Sensor (staple finisher rear tamper home)
"Staple finisher right cover removal" on page
"Staple finisher right cover removal" on page
"Staple finisher controller board removal" on page
"Staple finisher inner rear cover removal" on page
Repair information
825
787.
788.
787.
2 3
787.
787.
7564
795.
822.
824.
790.
795.