Lexmark CX825 Service Manual page 567

Action
Step 10
Check the cable for cuts or damage, and replace if necessary.
Does the problem remain?
Step 11
a
Check the staple finisher bin for damage.
b
Manually push, and then release the bin. Make sure that it
returns to its default position.
c
Clear the bin of any obstructions.
Is the bin properly installed or free of damage?
Step 12
Reinstall or replace the bin. See
page 832.
Does the problem remain?
Step 13
a
Check the staple finisher bin arms for damage.
b
Check the bin arms and spring for proper installation.
Are the bin arms properly installed or free of damage?
Step 14
Reinstall or replace the bin arms. See
assembly removal" on page
Does the problem remain?
Step 15
Check the lock assembly. Make sure that the following
components are free of damage:
•
Snap
•
Handle
•
Lock actuator
•
Interface connector and its pins
Are the components free of damage?
Step 16
Replace the damaged component.
Does the problem remain?
"Staple finisher bin removal" on
"Staple finisher bin clamp
846.
Diagnostic information
567
Yes No
Go to step 11. The problem is
solved.
Go to step 13. Go to step 12.
Go to step 13. The problem is
solved.
Go to step 15. Go to step 14.
Go to step 15. The problem is
solved.
Go to step 17. Go to step 16.
Go to step 17. The problem is
solved.
7564