Lexmark CX825 Service Manual page 332

Action
Step 22
Reinstall or replace the paddle and exit drive. See
paddle and exit drive removal" on page
Does the problem remain?
Step 23
Check the MSHPF compiler tray and its spring for proper
installation.
Is the compiler tray properly installed?
Step 24
Check the compiler tray and its plastic guides for wear and
damage.
Is the compiler tray free of damage?
Step 25
Reinstall or replace the compiler tray. See
removal" on page 1153.
Does the problem remain?
Step 26
a
Enter the Diagnostics menu, and then navigate to:
Output device diagnostics > Sensor tests > Finisher
b
Find the sensor (Compiler stack height).
Does the sensor status change while toggling the sensor?
Step 27
Reseat the sensor cable, and then check the sensor for
misalignment and damage.
Is the sensor properly installed and free of damage?
Step 28
Reinstall or replace the sensor. See
height) removal" on page
Does the problem remain?
Step 29
a
Enter the Diagnostics menu, and then navigate to:
Output device diagnostics > Motor tests > Finisher > Compiler
stack height
b
Touch Start.
Does the motor run?
"Compiler
1140.
"MSHPF compiler tray
"Sensor (compiler stack
1134.
Diagnostic information
332
Yes No
Go to step 23. The problem is
solved.
Go to step 24. Go tos tep 25.
Go to step 26. Go to step 25.
Go to step 26. The problem is
solved.
Go to step 29. Go to step 27.
Go to step 29. Go to step 28.
Go to step 29. The problem is
solved.
Go to step 32. Go to step 30.
7564