Lexmark CX825 Service Manual page 526

•
AA Result 11—Coarse exceeds margin limits
•
AA Result 12—Coarse corrections applied
•
AA Result 13—Normal exceeds skew limits
•
AA Result 14—Coarse exceeds skew limits
•
AA Result 15—Coarse new ITU speed
•
AA Result 16—AA characterization successfully completed
•
AA Result 17—AA characterization deficient, using defaults
•
AA Result 18—AA Manufacturing mode successfully completed
•
AA Result 19—AA Manufacturing mode deficient, not updating the results
4
Enter the Diagnostics menu, and then navigate to:
Printer setup > EP setup > Toner patch sensor adjust > Full calibration
Let the calibration run for one minute.
Note: This will also trigger the Auto Align routine (0.42 mm—Normal range only).
Action
Step 1
a
From the home screen, touch Settings > Reports > Print quality
pages.
b
On the Device information section of the Print quality test page,
check the Color Alignment Stat value.
Note: If the value is 1, then the sensors (auto alignment) are
working.
Is the value equal to 0?
Diagnostic information
526
Yes No
Go to step 2. The problem is
solved.
7564