Lexmark CX825 Service Manual page 373

Action
Step 11
Reseat the sensor cable, and then check the sensor for
misalignment and damage.
Is the sensor properly installed and free of damage?
Step 12
Reinstall or replace the sensor. See
upper limit) removal" on page
Does the problem remain?
Step 13
a
Enter the Diagnostics menu, and then navigate to:
Output device diagnostics > Sensor tests > Finisher
b
Find the sensor (Stapler bin paper present).
Does the sensor status change while toggling the sensor?
Step 14
Reseat the sensor cable, and then check the sensor and its
actuator for misalignment and damage.
Is the sensor properly installed and free of damage?
Step 15
Reinstall or replace the sensor.
Does the problem remain?
Step 16
Check the MSHPF stapler bin for misalignment and damage.
Note: Make sure that the shaft aligns with the gear.
Is the bin properly installed and free of damage?
Step 17
Turn the elevator gears and check if the bin moves from top to
bottom.
Does the bin properly move?
Step 18
Remove the obstructions along the bin path.
Does the problem remain?
Step 19
Reinstall or replace the bin.
Does the problem remain?
"Sensor (stapler bin stack
962.
Diagnostic information
373
Yes No
Go to step 13. Go to step 12.
Go to step 13. The problem is
solved.
Go to step 16. Go to step 14.
Go to step 16. Go to step 15.
Go to step 16. The problem is
solved.
Go to step 17. Go to step 19.
Go to step 20. Go to step 18.
Go to step 19. The problem is
solved.
Go to step 20. The problem is
solved.
7564