Sensor (Staple Finisher Upper Bin Full) Removal - Lexmark CX825 Service Manual

Sensor (staple finisher upper bin full) removal
1
Remove the right cover. See
2
Remove the rear cover. See
3
Remove the controller board. See
4
Remove the inner rear cover. See
5
Remove the two screws (A).
6
Remove the screw (B), disconnect the cable (C), and then remove the sensor (staple finisher rear upper bin
full—receiver).
7
Remove the front cover. See
"Staple finisher right cover removal" on page
"Staple finisher rear cover removal" on page
"Staple finisher controller board removal" on page
"Staple finisher inner rear cover removal" on page
B
"Staple finisher front cover removal" on page
Repair information
798
787.
788.
A
C
787.
7564
790.
795.