Lexmark CX825 Service Manual page 599

4
Turn the screw clockwise in half turn increments to adjust the printhead. Check the test page for alignment.
Note: Repeat this step until the skew on the test page is corrected.
5
Tighten the printhead clamp screw.
Aligning a printhead skewed in the counterclockwise direction
The following test page result shows a test page skewed in the counterclockwise direction:
1
Remove the vent cover, see
"Printhead fan removal" on page
2
Using a 3‑mm ball hex wrench (B), turn the printhead clamp hex screw (A) counterclockwise by one turn.
"Vent cover removal" on page
634.
B
A
Repair information
599
628, or remove the inner right cover, see
7564