MSHPF staple unit carriage removal
Note: Make sure that the staple carriage is in the service position. Before turning off the printer, enter the
Diagnostics menu, and then navigate to Output device diagnostics > Motor tests > Finisher > Staple unit,
service position.
1
Remove the MSHPF controller board cover. See
2
Remove the MSHPF right cover. See
3
Remove the MSHPF bottom right cover. See
4
Remove the MSHPF rear cover. See
5
Remove the two screws (A), and then open the cage.
"MSHPF controller board cover removal" on page
"MSHPF right cover removal" on page
"MSHPF bottom right cover removal" on page
"MSHPF rear cover removal" on page
A
Repair information
944
922.
923.
931.
7564
930.