When installing the stack clamp:
•
Pay attention to the exact position of the lower part of the clamp.
•
Push down, and then release the clamp to verify if it is properly installed.
Staple finisher stack clamp solenoid removal
1
Remove the right cover. See
2
Remove the rear cover. See
3
Remove the inner rear cover. See
4
Remove the ejector. See
5
Remove the staple unit bracket. See
6
Remove the bottom cover. See
"Staple finisher right cover removal" on page
"Staple finisher rear cover removal" on page
"Staple finisher inner rear cover removal" on page
"Staple finisher staple unit ejector removal" on page
"Staple finisher staple unit removal" on page
"Staple finisher bottom cover removal" on page
Repair information
810
787.
788.
795.
803.
805.
794.
7564