Lvps Removal - Lexmark CX825 Service Manual

6
Disconnect the cable JF1 from the controller board, and then remove the four screws (A).
Note: Take note of the correct fan direction and position.
7
Remove the fan.
Installation note: Route the cables through the guides properly.

LVPS removal

CAUTION—SHOCK HAZARD: The low‑voltage power supply (LVPS) may have residual voltage present.
To avoid the risk of electrical shock, do not touch its circuit components. Only handle it by its outer
edges.
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet, and then from the printer.
3
Remove the controller board cover. See
4
Remove the rear lower cover. See
5
Remove the rear upper cover. See
6
Remove the left upper cover. See
7
Remove the rear left cover. See
"Controller board cover removal" on page
"Rear lower cover removal" on page
"Rear upper cover removal" on page
"Left upper cover removal" on page
"Rear left cover removal" on page
Repair information
679
A
671.
672.
672.
605.
673.
7564