Isolation Roller Gear Removal - Lexmark CX825 Service Manual

10
Remove the ground screw (F), and then disconnect the cables (G).
11
Remove the gearbox.
Installation note: Make sure that the motor covers are installed and the cable ties are replaced.

Isolation roller gear removal

1
Remove the left door, duplex, and MPF. See
2
Remove the MPF pick roller. See
3
Remove the MPF pick guide. See
4
Remove the MPF tray stop. See
5
Remove the sensor (MPF/pass-through) with deflector. See
removal" on page 622.
6
To access the isolation roller gear, pull out the reference edge motor gearbox. See
gearbox removal" on page
"Left door, duplex, and MPF removal" on page
"MPF pick roller removal" on page
"MPF pick guide removal" on page
"MPF tray stop removal" on page
623.
Repair information
626
F
G
616.
617.
619.
"Sensor (MPF/pass-through) with deflector
7564
613.
"Reference edge motor