Replacing Staple Cartridge (For C3 Finisher Or C3 Finisher With Booklet Maker) - Fuji Xerox ApeosPort-V 5070 Administrator's Manual

3 Maintenance
6
Push the staple cartridge into the finisher until
it clicks into place.
7
Close the finisher front door.
Note
Replacing Staple Cartridge
(for C3 Finisher or C3 Finisher with Booklet Maker)
When the C3 Finisher (optional) or the C3 Finisher with Booklet Maker (optional) is installed
3
and the staple cartridge needs to be replaced, a message appears on the touch screen.
When this message appears, load a new staple case into the staple cartridge.
The Staple Cartridge [R1] is running out of
staples. Check the Staple Cartridge [R1] and
order staples.
The Staple Cartridge [R1] is out of staples or not
fully inserted. Check the Staple Cartridge [R1].
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Note
1
Make sure that the machine is not operating,
and open the finisher front door.
2
With grasping the lever [R1] of the staple
cartridge holder, pull the holder to the right,
towards you.
70
• If the front door is not closed completely, a message appears and the machine will remain paused.
Message
Use only staple cartridges recommended by Fuji Xerox.
• If the staple cartridge was not replaced properly, the message remains on the touch screen. Follow
the procedure and replace the staple cartridge again.
• To order a staple cartridge, contact our Customer Support Center.
Solution
Prepare new staples.
Note • Staples cannot be replaced yet.
Replace staples with new ones.