Installing A 2.5-Inch Hdd/Ssd Dummy Module; Concluding Steps - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

7.4.7.3

Installing a 2.5-inch HDD/SSD dummy module

V
CAUTION!
If the removed HDD/SSD module is not replaced immediately, always
replace a dummy module into the unused HDD/SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.
Figure 125: Installing a 2.5-inch HDD/SSD dummy module
Ê Push the HDD dummy module into the drive bay until it locks in place.
7.4.7.4

Concluding steps

Ê If applicable, "Reassembling" on page 67
TX1330 M4
Hard disk drives (HDD) / solid state drives (SSD)
Upgrade and Maintenance Manual 209