Installing A 2.5-Inch Hdd / Ssd Dummy Module; Concluding Steps - Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

7.2.3.3

Installing a 2.5-inch HDD / SSD dummy module

V
CAUTION!
If the removed HDD / SSD module is not replaced immediately, always
replace a dummy module into the unused HDD / SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.
Figure 41: Installing a 2.5-inch HDD / SSD dummy module
Ê Insert the HDD dummy module into the drive bay and push it backward until
locks in place.
7.2.3.4

Concluding steps

Perform the following procedures to complete the task:
Ê Install the hard disk drive cover as described in section
cover" on page
TX1320 M1
65.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Mounting the drive
125