Installing A 2.5-Inch Hdd/Ssd Dummy Module; Concluding Steps - Fujitsu PRIMERGY RX2560 M2 Upgrade And Maintenance Manual

7.2.11.3 Installing a 2.5-inch HDD/SSD dummy module

V
CAUTION!
If the removed HDD/SSD module is not replaced immediately, always
replace a dummy module into the unused HDD/SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.
Figure 90: Installing a 2.5-inch HDD/SSD dummy module
Ê Push the dummy module into the empty bay until it engages.

7.2.11.4 Concluding steps

Ê When working on a tower server, close the HDD bay cover as described in
section "Installing accessible drive and HDD bay covers" on page
TX2560 M2 / RX2560 M2
Hard disk drive (HDD) / solid state drive (SSD)
Upgrade and Maintenance Manual
83.
177