Management Route - Dell C9000 Series Reference Manual

management route

Configure a static route that points to the Management interface or a forwarding router.
C9000 Series
Syntax
management route {{ip-address mask | {ipv6-address prefix-length}}
{forwarding-router-address | managementethernet | fortyGigE | vlan
| gigabitethernet | tengigabitethernet}}
To remove a static route, use the no management route{{ip-address mask |
{ipv6-address prefix-length}}{forwarding-router-address |
managementethernet | fortyGigE | vlan | gigabitethernet |
tengigabitethernet}} command.
Parameters
ip-address mask
ipv6-address
prefix-length
forwarding-
router-address
managementethe
rnet
fortyGigE
vlan
gigbitethernet
tengigabitethernet Enter the keyword tengigabitethernet to specify a ten Gigabit
Defaults Not configured.
Command Modes CONFIGURATION
Enter an IP address (dotted decimal format) and mask (/prefix
format) of the destination subnet.
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix
format) of the destination subnet. Enter the IPv6 address in the
x:x:x:x::x format followed by the prefix length in the /x format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter an IP address (dotted decimal format) or an IPv6 address
(x:x:x:x::x format) of a forwarding router.
Enter the keyword managementethernet for the Management
interface on the Primary RPM.
Enter the keyword fortyGigE to specify a forty Gigbit Ethernet
interface.
Enter the keyword vlan to specify a vlan interface.
Enter the keyword gigabitethernet to specify a one Gigabit
Ethernet interface.
Ethernete interface.
IPv4 Routing 1207