To Stop Scanning/Printing - imagistics DL850 Operating Manual

To Stop Scanning/Printing

To cancel the tandem copying job:
1.
Press [ Stop ] on the control panel of the primary copier.
The scanning/printing job stops immediately, and the popup menu appears on the
Basic Screen of the primary copier to ask you whether to continue or terminate the
job. At this time, the tandem mode is not released.
2.
Touch CONTINUE to go on, or EXIT to delete all the scanned data
and to release the tandem mode.
To cancel the job in the secondary copier only:
1.
Press [ Stop ] on the control panel of the secondary copier.
The secondary copier stops the current operation immediately, and the popup menu
appears on the Basic Screen of the secondary copier to ask you whether to continue
or cease the operation. At this time, the tandem mode is not released.
2.
Touch CONTINUE to go on, or EXIT to delete all the data transmitted to
the secondary copier and to release the tandem mode.
The primary copier will take over the remaining print quantity and complete the job.
7-30
Using Two Copiers in Tandem (continued)
DETAILS
If temporary suspension in the secondary copier takes a long time, the
Allocation recovery mode will activate, enabling the primary copier to
handle the remaining print quantity.
DETAILS
Once the Allocation recovery mode is activated and the primary copier is
already handling the remaining print quantity, the secondary copier cannot
continue with the tandem printing job, even when CONTINUE is touched
on the popup menu.