To Specify Desired Copy Size (Ams) - imagistics DL850 Operating Manual

To Specify Desired Copy Size (AMS)

When a copy size is specified on the touch screen, an appropriate reduction or
enlargement ratio will be selected automatically according to the original size detected
from the EDH or the platen glass.
• Wide paper size can be specified when AMS is in use.
In this case, the same magnification ratio as that of the standard size
will be selected automatically.
• If copying in 1.000 (100%) magnification mode and specifying a copy
size, see p. 3-15.
1.
Touch a tray key on the Basic Screen to select the desired copy size.
Selected tray key will be highlighted, and under the LENS MODE AMS indication will
also be highlighted.
2.
Select additional copy conditions, as desired.
3.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
4.
Position original(s).
• See p. 11-8 to p. 11-10 for copy sizes detectable from the EDH or on the
platen glass.
• See p. 3-2 to p. 3-6 for details on positioning originals.
Selecting Copy Size (continued)
HINTS
HINT
HINTS
3
C opying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Copy Size
Lens Mode
Density
1-1, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
Finisher
Output Modes
Binding
Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
3-13