imagistics DL850 Operating Manual page 126

2.
Set copy conditions, as desired.
The initial settings in Interrupt mode are as follows.
Copy Mode
EDH
AES
Lens Mode
APS
Print Quantity : 1
Finisher
3.
Position original(s).
4.
Press [ Start ] to start the interrupt copying.
5.
When Interrupt copying is completed, press [ Interrupt ] again.
The [ Interrupt ] LED turns out and the INTERRUPT indicator on the Basic Screen
returns to the JOB indicators.
The settings of the initial job will be restored on the Basic Screen.
6.
Press [ Start ] to resume copying.
3-58
: 1a1
: ON
: ON
: 1.000 (100%)
: ON
: Main Tray in Sort mode
DETAILS
Remove any document from the platen glass or from the EDH, if present.
HINT
See p. 3-2 to p. 3-6 for details on positioning originals.
DETAILS
When [ Mode Check ] is pressed during Interrupt copying, the information
displayed reflects the initial copy job settings. Check mode will not display
Interrupt copy job information.
CAUTION
When the finisher / trimming unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
Interrupt Copying (continued)