Copier Initial Setting - imagistics DL850 Operating Manual

[2] Copier Initial Setting

Initial settings are the settings that display automatically when the copier is powered
on, when Panel Reset timer is operated, or when [ Panel Reset ] key is pressed. These
settings can be changed by the Key Operator, as shown in this section.
Initially (i.e., at installation), the Basic Screen displays the following conditions to meet
Energy Star requirements:
Initial Setting
Copy Mode
Copy Density
Lens Mode
Paper Tray
Output Mode
When Initial settings are changed by the Key Operator, the new initial settings display
when the copier is powered on, when Panel Reset timer is reached, or when [ Panel
Reset ] key is pressed.
The following initial settings can be changed by the Key Operator:
Copy mode
Copy density
Lens mode
Paper tray
Output mode
Special original : [Original Direction; Text/Photo Enhance; Special Original;
Rotation
Setting procedures are described on the following pages.
13-10
: 1-1
: AES
: 1:1
: APS
: offset sort
: [EDH; 1-1; 1-2; 2-2; 2-1]
: [AES; manual]
: [AMS; ratio 0.250~4.000]
: [APS; trays 1, 2, 3, or LCC]
: [Non-sort; Sort, Group; Staple-sort; Stapling&Folding;
Folding; Punch; Trimming; Cover sheet]
Original Form]
: OFF
NOTE:
The most commonly-used settings are established at installation. Before
changing any of the copier settings, be sure that you understand the
overall and long-range effect of the change.