Punching File Holes In Copies (Punch); P Unching File Holes In Copies (Punch) - imagistics DL850 Operating Manual

Punching File Holes in Copies (Punch)

The Punch mode is available only when the 9976 Punch kit or 9928 Z-Fold & Punch
unit option is installed on the 9982/9980 Finisher.
When the Punch mode is selected in combination with any of the Primary (Main) tray
output modes, each copied sheet is punched and output to the Primary tray according
to the selected output mode.
• Some staple positions previously selected may conflict with this
function.
• Special size paper (STD size (special), Non STD size, Wide size)
cannot be punched.
• The LCC specified as Thick 3 cannot be used.
• If the ATS (Automatic Tray Switching) functions while the machine uses
the Punch mode, the punch holes may be slightly off the appropriate
positions.
• Do not punch special paper type such as transparent films, labels, tabbed
sheets, etc. Otherwise, machine trouble may occur in Punch kit.
• Be sure that the side guide plates of the paper tray are securely aligned
to the paper; otherwise the copies may not be punched in position.
>>>Specifications for Punch Mode<<<
❒ Copy paper size: 11"x17", 8.5"x11" (20 lb paper recommended)
❒ Paper weight: 20 ~ 24 lb
Thin paper: 16 ~ 19 lb
Thick paper: 25 ~ 45* lb
❒ Number of holes: 3 holes
❒ Hole diameter: 0.315" ± 0.020" (8 mm ± 0.5 mm)
❒ Hole pitch: 4.252" ± 0.020" (108 mm ± 0.5 mm)
❒ Incompatible Conditions: Using platen glass (available when using Platen store
mode), Folding, Stapling & Folding, Trimming, Output to Secondary (sub) tray,
Mixed Original (8.5"x11"R, 5.5"x8.5" mixed), Non STD Size, Booklet, Transpar-
ency Interleave
DETAILS
Reminder!
* Some 45 lb paper types may not be punched easily.
4.252"
(108 mm)
Weekly
Timer
Rotation
Vertical/Hori-
zontal Zoom
Folding /
Stapling&Folding
Punch
Z-Folding
Trimming
Cover Sheet
Feeding
Using Finisher
Manually
Tandem Mode
7
A dvanced
Information
7-11