Selecting Magnification Ratio (Lens Mode); S Electing Magnification Ratio (Lens Mode); To Copy In 1.000 Magnification Mode - imagistics DL850 Operating Manual

Selecting Magnification Ratio (Lens Mode)

When the copier is turned ON, the magnification ratio is set to 1.000 (100%)
automatically on the Basic Screen.
Follow each procedure described in this section to select the desired magnification
ratio.

To Copy in 1.000 Magnification Mode

Follow this procedure to make a 100% copy of the original image.
1.
Close the EDH securely, then press [ Panel Reset ].
The initial settings are restored. Check that APS is highlighted to indicate that the
1.000 magnification is selected.
The initial settings may be altered by the Key Operator. See p. 13-10 to p.
13-11.
2.
Select additional copy conditions, as desired.
Specifying copy size will release 1.000 magnification and set AMS automatically.
In this case, touch 1:1 to highlight it again.
3.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
4.
Position original(s).
See p. 3-2 to p. 3-6 for details on positioning originals.
5.
Press [ Start ].
HINT
DETAILS
HINT
HINT
3
C opying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Copy Size
Lens Mode
Density
1-1, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
Finisher
Output Modes
Binding
Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
3-15