Non-Image Area Erase Setting; N On-Image Area Erase Setting - imagistics DL850 Operating Manual

[20] Non-Image Area Erase Setting

Select the mode of Non-Image Area Erase function to be in effect when this feature is
selected on the Application Selection Screen after power is turned on or after Panel
Reset occurs.
Key Operator Mode Screen
Procedure
1 Touch [20] Non-image area erase setting on the Key Operator Mode Screen to
display the Non-Image Area Erase Setting Screen.
2 Select the desired erase mode and original density level.
Touch AUTO to let the machine select the erase mode and density level automatically.
To specify the erase mode manually, touch Oblique erase or Rectangle erase , as
desired, then select the density level required. Five exposure levels are provided.
3 Touch OK to complete the setting and restore the Key Operator Mode Screen.
4 If no further changes are required, touch PREVIOUS SCREEN to restore the Basic
Screen to perform copying operations.
13-52
NOTE:
Select AUTO mode if the specified Oblique or Rectangle Erase mode does
not function properly due to the type of set original.
Non-Image Area Erase Setting Screen