Loading Tabbed Sheets In Tray 1, 2, Or 3 - imagistics DL850 Operating Manual

Loading Tabbed Sheets in Tray 1, 2, or 3

When TAB is displayed on the tray key of the Basic Screen, follow the procedure
below to supply the tray with tabbed sheets.
Rear
Rear
1.
Withdraw tray 1, 2, or 3.
2.
Open the paper feed roller.
3.
Place the tabbed sheets on the tray as illustrated above.
4.
Move the green levers (located at the front and the left side) to the
edge of the paper.
5.
Close the paper feed roller, then push in the tray until it locks into
place.
2-28
HINT
The tray paper type can be specified in the Key Operator setting. For
details, see p. 13-23 to p. 13-24.
Example: 3 Tabbed sheets loaded in position for one finished set.
Front
1st TAB
2nd TAB
3rd TAB
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
Front
1st TABS
2nd TABS
3rd TABS
Reminder!
The tab extension width should be 12.5mm or less.
Loading Paper (continued)
Section 3
Management
Printed
side
ONE FINISHED SET
1st TAB
Section 3
Section 3
Management
Section 3
Management
Section 1
Management
Introduction
Printed
side
1st TAB
Section 1
2nd TAB
Introduction
3rd TAB
2nd TAB
Section 1
Section 1
Introduction
Introduction
3rd TAB
3 FINISHED SETS