imagistics DL850 Operating Manual page 370

No. 29: E.C.M. password
No. 30: Arrow key change <Image Shift>
No. 31: Exit direction (1 sheet, platen)
No. 32: An interruption suspended way
No. 33: E.C.M. password input timing
No. 34: Key click sound (No paper, toner/ JAM) OFF / 3 seconds / 5 seconds / 10 seconds
No. 35: Reserve copy function
No. 36: Scan stop by a pull out tray
No. 37: Change page no. pos. (booklet)
No. 38: Trimmer (STD/ Non STD size)
No. 39: Timer which prohibits Print
No. 40: Bookmark function
No. 41: Delete of overlay image
No. 42: Orig. direction/binding mode
No. 43: Image stored cont. (SRV)
No. 44: Image recalled cont. (SRV)
No. 45: Exit direction
Key Operator Mode Screen
Procedure
1 Touch [13] Memory switch setting on the Key Operator Mode Screen to display the
Memory Switch Setting Screen.
2 Use the procedure below to select the desired item and change the setting.
(1) Touch the arrow keys c and d at the right on the Memory Switch Setting Screen to
select the desired item.
(2) Touch the arrow keys
(3) Touch Change Setting Contents to change the setting of the highlighted item.
(4) Repeat above steps (1) to (3) to make several changes in succession.
3 Touch PREVIOUS SCREEN to restore the Key Operator Mode Screen.
13-40
[13] Memory Switch Setting (continued)
under 8 digits / 8 digits
Decimal point off (1 STEP 1mm) / Decimal
point on (1 STEP 0.1mm)
Face up / Face down
Division of a number of copies / During of a
number of copies
Panel reset timer / complete job
Reserve copy by folder select / Reserve
copy by original set
ON / OFF
OFF / ON (Outside page numbering)
STD size / Non STD size
OFF / 15 seconds / 30 seconds / 60 seconds
/ 90 seconds
ON (It is cancel every JOB) / ON (It is not
cancel every JOB) / OFF
Permission (Delete/Overwrite) / Prohibition
(Delete/Overwrite)
It is cancel every job / It is not cancel
OFF / ON
OFF / ON
Face down / Face up
Memory Switch Setting Screen
? @
and at the lower left to scroll the screen.