imagistics DL850 Operating Manual page 244

Repeating Automatically or Selecting Repeating Times
5.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
6.
Select the desired magnification and copy size.
7.
Enter the desired print quantity from the control panel keypad.
8.
Position original.
For AUTO mode original, open the EDH, then position the original FACE DOWN on
the platen glass.
For 2 Repeat, 4 Repeat or 8 Repeat mode original, EDH is also available.
9.
Press [ Start ].
9-38
(Repeat: AUTO/ Repeat Mode) (continued)
DETAILS
• APS and AMS are automatically released, and 1.000 (100%) is selected
as a magnification ratio.
• When 2 Repeat, 4 Repeat, or 8 Repeat is selected, the scanning area
will be a portion of the selected paper size equally divided according to
the selected mode.
In this case, magnification ratio will be fixed to 1.000 (100%).
• Copy mode is automatically set to 1a1. When selecting 1a2 mode,
Platen store mode will function automatically.
HINT
See p. 3-7 for details on setting print quantity.
HINT
See the illustration on p. 9-36 for details.
Reminder!
When AUTO mode is selected, Non-Image Area Erase functions automatically.
DO NOT close the EDH.
CAUTION
When the finisher / trimming unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
DETAILS
The AUTO mode may not operate properly if the lighting in the work place
is directly over the platen glass. In this case, consult your service represen-
tative about an appropriate place for installation.