Selecting Copy Size; S Electing Copy Size; To Select Copy Size Automatically (Aps); Density - imagistics DL850 Operating Manual

Selecting Copy Size

To select an appropriate copy size for getting your desired copy result, use APS
(Automatic Paper Selection), or select copy size manually on the touch screen, as
required.

To Select Copy Size Automatically (APS)

APS detects the size of originals placed on the EDH or platen glass and automatically
selects and feeds copy paper of the same size, or selects an appropriate size according
to the magnification ratio selected.
The initial settings may have been altered by Key Operator. See p. 13-10 to
p. 13-11.
1.
Touch to highlight APS at lower right corner of the Basic Screen.
APS is already highlighted when the initial settings are restored.
2.
Select additional copy conditions, as desired.
3.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
4.
Position original(s).
• See p. 11-8 to p. 11-10 for copy sizes detectable from the EDH or on the
platen glass.
• See p. 3-2 to p. 3-6 for details on positioning originals.
• Key Operator can deactivate APS when original is set in the EDH or on
the platen glass. See p. 13-39 to p. 13-44.
HINTS
HINT
HINTS
3
C opying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Copy Size
Lens Mode

Density

1-1, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
Finisher
Output Modes
Binding
Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
3-11